| Specifications: Available diode power modules:
5 VDC at 40 A (drives two 20-W cw bars in series)
5 VDC at 60 A (drives two 40-W cw bars in series)
10 VDC at 40 A (drives four 20-W cw bars in series)
Dual 5 VDC at 40 A (independently drives two sets of two 20-W cw bars in series)
(Quasi-cw modules under development)
Power module configuration:
As many as three power modules can be incorporated
Other standard functions:
Drive for electromechanical shutters
Interlock circuit sensing
Optional components
Acousto-optic Q-switch RF driver, controllable through software and external connections
Power supplies for nonlinear crystal ovens
Dimensions:
19" wide, 7" (4U) high, 20" deep
Weight:
28 to 35 lbs (dependent on options included)
Front Panel:
Key-switch for AC power
Power On LED
Fault LED
Illuminated push-button switch, software programmable for laser On/Off
Illuminated push-button switch, software programmable for shutter Open/Close
Rear Panel:
AC input with fuse
Two ¼ turn MS connectors - Diode Power and Control
RS-232 9-pin D-sub connector
Interlock connector - circular DIN
SMA feed-through for Q-switch RF
Q-switch External input and Monitor BNC connectors
Control and diagnostic features (via RS-232)
See MPL Software Specifications
Control Features (via BNC):
Q-switch (trigger mode)
Diagnostic Features (via BNC)
Q-switch monitor
Electrical: Operating voltage 100-250 VAC, 50-60Hz
Single Phase
Modules are power-factor corrected
RFI filters between power and power-factor correction circuit
Power consumption 450W to 1.1kW (options dependent)
Fuse protection - 10 amp (110V) / 5 amp (220V)
We reserve the right to alter these specifications
without notice. |
